Inventor Tutorial for the iDoor – 15

Inventor Tutorial for the iDoor – 15 – More Sketching the Raised Panel

The end result of this pair of lines should look like the image below, and the status bar should report the sketch as being fully constrained (only while in sketch mode).

Inventor Tutorial iDoor Page Fifteen Image 01 - Skeletal Modeling Sketch

The reasoning behind the method used for creating this sketch this way will become apparent later, but for now, we need a bit more geometry to complete it.

Inventor Tutorial iDoor Page Fifteen Image 02 - Panel Profile Animation

As you should be able to see in the animation above, start by grabbing the Line tool from the Draw Panel , and hover at the top of the small vertical line until the green constraint dot appears, then click to begin sketching. Sketch over to the right a short distance, making sure the Vertical Constraint Glyph is present, and click to create the first segment. Continue in the same direction, and again go a short distance, look for the Glyph, and click to create the second segment. Now go up perpendicular tothe first two lines a short distance, look for the Glyph, and click to create the third line, and again for the fourth line. Now move parallel to the long bottom line towards the far end of same, and look for both the vertical constraint glyph, and the dashed line down to the end of the bottom line and click. The last line segment is to close the loop by going to the end of the bottom line where you hover the cursor over it until you get the green constraint dot and click. Right click and chose Done or hit Esc on your keyboard to exit the command. Save the file.

Inventor Tutorial iDoor Page Fifteen Image 03 - More skeletal model sketching

The sketch should now look like the one above. Now we need to project a point. Double click the Panel profile sketch in the browser to activate it, then grab the Project Geometry tool from the Draw Panel . Hover near the point at the upper corner of the stile profile closest to you until it highlights, then click to project the point into the current sketch. Now turn off the visibility of the Stile Profiles sketch to better see the projected geometry.

Inventor Tutorial iDoor Page Fifteen Image 04 - Yet more skeletal model sketching

Inventor Tutorial for the iDoor Navigation

Intro123456789101112131415

1617181920212223242526272829

 

iDoor Tutorial One

Subscribe to Blog via Email

Top