Inventor Tutorial for the iDoor – 14

Inventor Tutorial for the iDoor – 14 – And More Yet Sketching!

Do the same thing from the other side towards the line just drawn…

 

Inventor Tutorial iDoor Page Fourteen Image 01 - Repeat on other side

Select the second (top) line, then on the Format Panel click on the Construction icon to change the line to construction geometry. It should now be a dashed blue line as shown below.

 

Inventor Tutorial iDoor Page Fourteen Image 02 - Select the top line

Now connect the two lines by creating a coincident constraint between their end points. Click on the Coincident Constraint tool to activate it, then click on the ends of both lines as shown below…

 

Inventor Tutorial iDoor Page Fourteen Image 03 - Connect the lines

The lines should now be connected as is shown below.

 

Inventor Tutorial iDoor Page Fourteen Image 04 - Connected lines

Now you will apply an Equal Constraint to the lines. Get the Equal tool from the Constrain Panel, and click on both of the lines as shown…

 

Inventor Tutorial iDoor Page Fourteen Image 05 - Apply equal constraint

Inventor Tutorial for the iDoor Navigation

Intro123456789101112131415

1617181920212223242526272829

iDoor Tutorial One

Subscribe to Blog via Email

Top