iLogic Tutorial From Autodesk – 09
Add Assembly Control Parameters
Since this is a new assembly document, we need to add some parameters using the iLogic Parameter Editor. For the following steps, open the iLogic Parameter Editor.
Create Parameters to Control Port Sizes
- Create a new parameter named “port_a_size”
- Set its type to User
- Set its unit to in
- Make it a Multi-value list, with the values: 0.50, 0.75, 1.00, 1.25, 1.50, 2.00, 2.50, 3.00
- Make it a key parameter
Repeat the above to create 2 more parameters: port_b_size and port_c_size.
Create Parameters to Control Component and Block Type
Create a parameter called component_type
- Set the type to String
- Create a Multi-Value list of: standard, custom
- Set the Multi-Value list to standard
- Make this a Key Parameter
Create a parameter called block
- Set the type to String
- Create a Multi-Value list of: tee, elbow
- Set the Multi-Value list to tee
- Make this a Key Parameter
Create Parameters to Control Component Part Numbers
Create 7 additional parameters. For each, set the type to String, and the value to 1. Call these:
- port_a_union_part_number
- port_b_union_part_number
- port_c_union_part_number
- port_a_screw_part_number
- port_b_screw_part_number
- port_c_screw_part_number
Your entire set of new parameters should look like this:
Before you continue, save the file.
Inventor iLogic Tutorial Navigation
Intro – 1 – 2 – 3 – 4 – 5 – 6 – 7 – 8 – 9 – 10 – 11 – 12 – 13 – 14 – 15 – 16 – 17 – 18