iLogic Tutorial for the iDrawer – 16

iLogic Tutorial – 16 – Extruding the Drawer Front

Now for the main front section with the pins. Turn on the visibility of the Base and Front Profile sketches, and position the model as shown below…

iLogic Tutorial for the iDrawer Page Sixteen Image 01 - Half Drawer Side

Select the Extrude tool from the Create panel and click on the profile, change the Extents to and select the point on the rigging shown in the image below, which is the endpoint of the rigging line that runs along the YZ plane

iLogic Tutorial for the iDrawer Page Sixteen Image 02 - The Drawer Front

…the preview will jump to the point as shown below…

iLogic Tutorial for the iDrawer Page Sixteen Image 03 - Extrude the Front Half

…then select the New solid button as shown in the image above, and click OK to create the solid body. Rename the extrusion Front A and the solid body Front. You should have something that looks like the image below.

iLogic Tutorial for the iDrawer Page Sixteen Image 04 - Completed Half Extrusions

Now for the pin cuts in the front solid. Turn on the visibility of the Cutter Front & Back sketches,  and turn off the visibility of the Right Side solid body. Rotate the model to get a view similar to the one below…

iLogic Tutorial for the iDrawer Page Sixteen Image 05 - Rotate The Model

– iLogic Tutorial for the iDrawer Navigation –

Intro12345678910111213141516171819

 

iDrawer Tutorial

Subscribe to Blog via Email

Top