iLogic Tutorial for the iDrawer – 13

iLogic Tutorial – 13 – Completing the Bottom Sketch

Its a good idea to shut of the visibility of all of the sketches except the Drawer Bottom Profile so that you are not seeing multiple center points. Now grab the Vertical Constraint tool from the Constrain panel and click the center point, then the center of the top line as shown below…

iLogic Tutorial for the iDrawer Page Thirteen Image 01 - Constrain Sketch

Do the same thing with a Horizontal constraint to the center of one of the side lines…

iLogic Tutorial for the iDrawer Page Thirteen Image 02 - Horizontal Constraint

You now need to use the reference parameters created earlier to create a formulae for the Drawer_Bottom_Width and Drawer_Bottom_Depth parameters. Open the parameter editor and change the following:

iLogic Tutorial for the iDrawer Page Thirteen Image 03 - an iLogic Parametric Formula

Now apply the two new parameters as shown below to finish this sketch…

iLogic Tutorial for the iDrawer Page Thirteen Image 04 - Compleated drawer Bottom Sketch

 

– iLogic Tutorial for the iDrawer Navigation –

Intro12345678910111213141516171819

 

iDrawer Tutorial

Subscribe to Blog via Email

Top