iLogic Tutorial for the iDrawer – 08

iLogic Tutorial – 08 – Creating the Dovetail Offset Reference Parameter

Now we need to add one last line that represents the offset of the cutter profile at the full cutter depth. Just start a line at the top of the lines you just created and run it beyond the upper horizontal line, and trim it to same, then add a dimension to the line, which will create a driven dimension that will describe the offset no matter what the angle or depth settings are set to…

iLogic Tutorial for the iDrawer Page Eight Image 01 - A Driven Dimension

…then open the Parameter Editor and rename the new driven dimension Cutter_Offset as shown below.

iLogic Tutorial for the iDrawer Page Eight Image 02 - Reference Parameters

Now change all geometry shown to construction geometry, then exit and save the sketch.

iLogic Tutorial for the iDrawer Page Eight Image 03 - Construction Geometry

– iLogic Tutorial for the iDrawer Navigation –

Intro12345678910111213141516171819

 

iDrawer Tutorial

Subscribe to Blog via Email

Top