iLogic Tutorial – Derived Block Library – 09

iLogic Tutorial –  09 –  More Cutting of the Profiles

Now connect the block to the projected point by either using a Coincident constraint between the two points shown below, or grab the block by the junction point (1) and drag it to the projected point (2).

iLogic Tutorial Derived Block Library Page Nine Image 01 - Place The Sketch Block

When you see the Coincident Constraint glyph and the green dot, click to accept.

iLogic Tutorial Derived Block Library Page Nine Image 02 - Drag The Sketch Block

The sketch should now be fully constrained. Now turn the visibility of the Profile Path back on, finish the sketch, and save.

iLogic Tutorial Derived Block Library Page Nine Image 03 - Finished Panel

The part should now look like the image above with the path visible around the upper edge and the profile buried in the part. Now we can cut the first profile.

 

– iLogic Tutorial for the Derived Block Library –

Intro12345678910111213

 

Derived Block Library

Subscribe to Blog via Email

Top